FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1649 total: showing 221-240)

Is it possible to remotely change the settings of a remote RF401A, such as through a radio-to-radio transmission?
If two RF401A radios are using different operating systems, does that affect their ability to communicate?
Is there a limit to the length of antenna cable that can be used with an RF401A?
Does initiating RF401A radios require dc power, or is power via the CS I/O connection OK?
Does the RF401A have any identified sensitivities to adjacent operating radio equipment?
Is there a setting to increase the power output of an RF401?
Is it possible to configure the RF401A as a stand-alone router?
Is there a maximum current that can be sourced through the SW12V?
Is there a maximum voltage that can be sourced through the SW12V?
Using an SW12V, can the 12 V power lead be run to a source other than the data logger 12 V?
What are the voltage and current requirements for toggling the switch of an SW12V?
When should the desiccant inside an enclosure be replaced?
What factors affect the amount of desiccant needed in an enclosure?
If LoggerNet is running on a PC, does that mean that LoggerNetData’s DataFiler can’t be used to access the cache for that instance of LoggerNet?
Why don’t mixed-array data logger tables show up in the Data Filer table selection window?
Where can the MAC (physical) address of an NL100 be found?
What might cause Baler to display “failed to create the file…” or an access permission error when starting up?
What can be done if a new table is not being baled by Baler?
With Baler, how can a user start fresh with a new configuration settings file?
Can Baler be used to push data from a Windows server to a Unix server?

Previous Next