FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1872 total: showing 261-280)

What is the difference between the microSD cards that Campbell Scientific sells and the cards that are commonly used in the consumer electronics at home?
Can the CS11-L activate a small relay?
Can the CS11-L be used to measure amperage from a battery?
Can the CS11-L be used in a three-phase power situation?
How can the CS11-L be used on a data logger other than a CR200(X)?
How is the CS11-L an improvement compared to the retired CS10-L and CS15-L?
Can an ST350 be used in instrumental pile load tests with cast-in-situ (bored) concrete piles?
What needs to be done to measure ST350 Strain Transducers using a Campbell Scientific data logger?
What is the microstrain limit for the ST350?
Is one 4WFBS350 or 4WFBS120 required for each ST350 connected to a data logger or multiplexer?
When should a guy kit be used on a CM106B?
When the GPSReady variable is not 10, does the data logger still synchronize with the PPS signal?
If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?
If the “gps_ready” output of the GPS() instruction is stuck at or near zero and the data logger clock is not being set, what might be the cause?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a data logger and then parsed out?
How can four GPS16X-HVS receivers be connected to the COM ports of a data logger to read all four NMEA strings?
What battery options are available for the 25295?
Does the regulator for the 25295 draw power from the battery during the night?
Does the regulator for the 25295 have the Low Voltage Disconnect feature?
What would happen if two data loggers were connected directly through CS I/O ports via an SC12 cable?

Previous Next