FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1649 total: showing 541-560)

Do data loggers need their own batteries, or can they be powered directly through a BP24?
Is the battery mounting bracket for the BP24 battery sold separately?
Does a BP24 need a CH100 to work with an unregulated solar panel, or can the BP24 be connected directly to a regulated solar panel?
Is there a battery test kit to test BP24 battery packs out in the field to make sure they are good?
Is there an SDS (safety data sheet) for the BP24?
Can an SDM-CAN be used to interface with a scanner running on 500 kbps RS-422?
Are 32 bit numbers too large for an SDM-CAN to handle?
Can the SDM-CAN interface receive data from an ISOBUS (11783) CAN system?
How do the SC929 and SC32B compare?
Can an SC929 be used to connect a data logger CS I/O terminal with a sensor that has an RS-232 output?
What size barrel connector is used on the 15988?
What is the difference between a PS24 and a BP24? Is a BP24 with a CH100 equivalent to a PS24?
If a site is located in a fairly arid location, yet the RH reading from the CS215-L is 100%, what might cause this erroneous reading?
If the CS215-L is displaying a -100 (actually a -99.999) for temperature and RH, what is wrong?
What maintenance is recommended for the CS215-L?
If the reported values for temperature and/or relative humidity from a CS215-L are not valid numbers, what should be done?
How can the CS300-L be mounted if the 18356 leveling base is not used?
On routine site visits, how can the calibration of the CS300-L be checked?
Is it possible to read the output from a CS300-L in a 4 to 20 mA form?
Can a CS300-L be calibrated to a smaller range to measure only PAR (photosynthetically active radiation)?

Previous Next