All FAQs (1743 total: showing 681-700)
- Can a SCADA system access data from a CR1000 or CR3000 connected to an NL115 without using LoggerNet?
- Will an NL115 enable a CR800 or CR850 to communicate over the Ethernet to a PC?
- Is it possible to retrieve data files through the FTP site when using the CR1000 with an NL115?
- Can an NL115 and a CR1000 or CR3000 communicate with DevConfig without using RS-232?
- What can be done if a memory card is not being completely filled with data?
- Is there a way of configuring the FTP, HTTP, and Telnet services remotely on a CR1000 or CR3000 with an NL115?
- Where can the MAC (physical) address of an NL115 be found?
- Does an NL115 need a dynamic or static IP?
- What is an alternative to using an NL115 or CFM100 and storing data to a card?
- Using PC200W, how can a CR1000 be instructed to send data to the SC115?
- Is it possible to automatically encrypt the data stored on an SC115?
- Can the SC115 be used with an NL115 2 GB card to increase the storage capacity to 4 GB?
- What is needed to have the data logger automatically download data to the SC115?
- How can the SC115 be used?
- After remotely uploading an operating system, how can the NL201 be reset?
- Can the operating system (OS) in an NL201 be updated remotely?
- What are the calibration procedures for the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH, and how are they traceable to the National Institute of Standards and Technology (NIST)?
- Is the crosswind correction applied to the raw data of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
- Can the CSAT3/3A/3AH give a time stamp with each measurement value?
Previous
Next