FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1649 total: showing 781-800)

How does the KH20 work?
What is PakBus™ encryption?
Can files on a PakBus™ data logger be hidden?
Which data logger files can be encrypted?
How effective are pass-code lockouts for CRBasic PakBus™ data loggers?
How can a data logger be made more secure?
Is there a module to read a group of fine-wire thermocouples?
Can Campbell Scientific fine-wire thermocouples measure the temperature of a 50 µm by 50 µm flat surface?
Is it possible to measure the absolute temperature with an accuracy of 0.01°C using the FW05? Or do the thermocouple output error and the thermocouple voltage error inhibit such accuracies?
How is sensible heat flux measured using a CSAT3/3A/3H and an FW05?
To measure sensible heat flux using the eddy-covariance technique, which fine-wire thermocouple should be used?
How can the pulse output of a 03101 be converted to a 4 to 20 mA output?
If a cup breaks off the 03101, can the cup be replaced, or is a new sensor needed?
What might cause a 03101 to produce a signal that is not high enough to be registered by the magnetic pickup?
How is the 03101, with its offset fitting and strain relief, mounted to the conversion kit?
Can the 03101 be installed in a position that is tilted to the horizontal?
Is a device, such as the COM320, necessary for initiating a call when the measured parameters fall out of a specified range?
Can dual communication modes be run on a single CR1000 using a COM320 and an NL120?
Can a CWS900-series interface make thermocouple measurements?
How many CWS900-series interfaces can be put inside an enclosure, such as the ENC10/12, without causing interference issues?

Previous Next