FAQs Frequently Asked Questions about Our Products and Solutions

Ask a Question Ask a Question

All FAQs (1649 total: showing 1401-1420)

What principle does the control line of the CE4 and CE8 work with? Is it a digital signal or an analog voltage?
Can a CE4 or CE8 be used as a current source, measuring the voltage drop across a resistor to calculate resistance?
Can the CE4 and CE8 be used to make measurements of a non-bridged PRT?
If a data logger is not registering any tips from a rain gage, what can be done?
What are the indicators that a tipping bucket rain gage has a faulty reed switch?
What can cause a data logger to not receive correct tipping data from a rain gage?
What are the steps to perform a field calibration check on a TB4, a TB4MM, or a CS700?
What can cause a tipping bucket rain gage to be out of calibration?
What are the indicators that a tipping bucket rain gage is out of calibration?
What are the most common errors with a tipping bucket rain gage?
Can the A200 be used to monitor the input and output of pressure and temperature transducers through a computer?
Why might an SDMX50-series multiplexer make clicking sounds?
Are SDMX50-series and SDM8X50 multiplexers only usable with the TDR100 or TDR200 system?
Does an SDMX50-series multiplexer require a separate power supply?
How far can an SDMX50-series or SDM8X50 multiplexer be separated from a TDR100 or TDR200?
Where is PC-TDR available for download?
How can two independent solar power systems be connected to an AP200 if each system has a lead-acid battery, solar panel, and charger?
Where should a sensor that requires 12 Vdc power be connected to on the AP200?
Why does the AP200 system use so much power at lower temperatures?
If the power cord is too short on the 28549 power adapter kit, can an extension cord be used?

Previous Next