All FAQs (1743 total: showing 621-640)
- Can a 10164-L Water Sampler Control Cable be used to interface Campbell Scientific data loggers with ISCO water samplers?
- What is the maximum solar panel size that can be connected to a PS100?
- How long does it take to fully charge the PS100 battery?
- Is there a published chart of charging voltage versus temperature for the PS100?
- Can the PS100 handle a 55 W solar panel, or should an external regulator be used?
- Is there a way to record the average influx of energy into the PS100 battery (that is, from a solar source)?
- What are the internal and external battery connections on the PS100 used for?
- Can an RV battery be used to replace the battery in the PS100?
- Can the PS100 be purchased without the 7 Ah rechargeable battery?
- On the PS100, what might cause the “charging voltage present” light to be off?
- Should an idle PS100 be left on charge continuously, or should it be allowed to self-discharge?
- Do the PS100 batteries come charged?
- Is the red LED on the PS100 supposed to turn green when the battery is charged?
- Will the PS100 or PS200 work as a battery backup for the CR1000?
- If a group of switching power supplies is being powered by the same circuit as a PS100, will noise on the line affect the operation and accuracy of the data logger, multiplexer, and modem?
- What is involved in replacing the battery of a PS100?
- If a PS100 battery is no longer holding a charge well, should the battery be replaced?
- Can a PS100 be charged from 24 Vdc?
- Can a PS100 be charged from a 12 V, 100 Ah battery?
- If a spare PS100 or PS200 is sitting on a shelf, should it be periodically charged?
Previous
Next