All FAQs (1649 total: showing 641-660)
- Where can the MAC (physical) address of an NL115 be found?
- Does an NL115 need a dynamic or static IP?
- What is an alternative to using an NL115 or CFM100 and storing data to a card?
- Using PC200W, how can a CR1000 be instructed to send data to the SC115?
- Is it possible to automatically encrypt the data stored on an SC115?
- Can the SC115 be used with an NL115 2 GB card to increase the storage capacity to 4 GB?
- What is needed to have the data logger automatically download data to the SC115?
- How can the SC115 be used?
- After remotely uploading an operating system, how can the NL201 be reset?
- Can the operating system (OS) in an NL201 be updated remotely?
- What are the calibration procedures for the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH, and how are they traceable to the National Institute of Standards and Technology (NIST)?
- Is the crosswind correction applied to the raw data of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
- Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
- Can the CSAT3/3A/3AH give a time stamp with each measurement value?
- What is the direction definition of vertical wind speed for a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH? For example, does a negative value mean upward or downward?
- What should be done if the CSAT3/3A/3AH cannot be found in the Short Cut list of sensors?
- Are there any data logger programming changes that must be made to a program when using a long Synchronous Device for Measurement (SDM) cable with a CSAT3?
- Can a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used to measure wind flow angle, horizontal angle, and wind speed for the purpose of power curve testing?
- If the polymer coating at the ends of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH transducers starts coming off, is that a problem?
- What is the absolute accuracy of the speed of sound measurement in the CSAT3/3A/3AH?
Previous
Next